Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 530 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

4 questions · 8 marks

Pick again
Print
1Short recall2 marksUnits & Conversion Swap Remove

Data storage is measured in binary multiples.

Define the term bit.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • A binary digit (1)
  • Has the value 0 or 1 (1)
  • The smallest unit of data storage (1)
  • A single 0 or 1 (1)

Allow binary digit/binary place value for binary digit

Allow a single binary digit for a single 0 or 1

Do not accept a group of 8 bits/half a nibble of 4 bits, which describe a byte or a nibble

Do not accept a binary number/binary on its own

Example answers and how they were marked
Full marks2/2

A binary digit that can have the value 0 or 1.

Why: A binary digit (1) and has the value 0 or 1 (1).

Some marks1/2

It is the smallest unit of data storage.

Why: Smallest unit of data storage (1), but does not state that it is a binary digit or that it has the value 0 or 1.

No marks0/2

A group of 8 bits.

Why: Describes a byte, not a bit; no creditworthy point and named in the Do not accept line.

2Describe2 marksLow and High Level Languages Swap Remove

A device driver is software that allows the operating system to control a piece of hardware. Device drivers are often written in a low-level programming language.

Describe one reason why a low-level programming language is suitable for writing a device driver.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • Instructions can manipulate/control the hardware/memory/registers directly (1) so the driver can control the specific device it is written for (1)
  • The code is written for one specific processor/architecture (1) so it works with the exact hardware it will control (1)
  • The programmer controls exactly how memory/registers are used (1) so the code is efficient and needs little memory, which suits a device that has limited memory (1)
  • Each instruction maps to one machine code instruction (1) so the driver code is small enough to fit in the memory of the device (1)

Extra detail, such as naming the device the driver controls, is not needed to earn the marks.

Do not accept 'it is closer to machine code' on its own: it must be developed to show how this helps the driver, e.g. it can control the hardware directly.

Do not accept 'it is faster/quicker' with no link to the hardware/device, e.g. the device responds quickly.

Do not accept 'it is easier to learn', 'it is easier to debug' or 'it takes less time to write'.

Example answers and how they were marked
Full marks2/2

Low-level instructions can manipulate the hardware and memory directly (1) so the driver can control the specific device it was written for, such as a sound card (1).

Why: Point about direct control of hardware/memory (1) linked to controlling the specific device (1). The named device is extra detail and is not needed.

Some marks1/2

Low-level instructions can manipulate the hardware directly.

Why: Correct point (1) but no linked development saying how this helps the device driver.

No marks0/2

It is closer to machine code so it runs faster than a high-level language.

Why: 'Closer to machine code' is not developed into how this helps the driver, and 'runs faster' is not linked to the hardware/device, so no mark.

3Explain2 marksThe Internet Swap Remove

Every device that connects to the internet is given an IP address.

Explain one reason why every device on the internet needs a unique IP address.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • Data/packets are delivered to the correct device (1) because the IP address identifies that device on the internet (1)
  • A reply is sent back to the device that made a request (1) because the sender's IP address is used as the destination address for the reply (1)
  • Routers can forward packets to the right device (1) because each packet's destination IP address matches only one device (1)
  • A device can be contacted by other devices (1) because other devices use its IP address to send data to it (1)

For both marks, the expansion must follow/associate with the statement.

Allow 'so the router knows where to send data' only when expanded to say the IP address identifies the destination device / is used by routers to forward the packet to that device.

Do not accept 'so it can connect to the internet' / 'so it can access the internet' without saying how the address is used to identify the device or deliver data to it.

Do not accept 'so the device can be identified' on its own without saying what the identification is used for, e.g. delivering data or returning a reply.

Do not award a mark for restating that an IP address is unique / every device has a different address.

Example answers and how they were marked
Full marks2/2

So that data reaches the correct device. The IP address is how the internet tells one device apart from another, so packets are sent to that device and not to a different one.

Why: Point (1): data reaches the correct device. Reason (1): the IP address identifies/tells devices apart, so packets are sent to that device.

Some marks1/2

So that packets go to the right device, because every device has a different address.

Why: Point (1): packets go to the right device. The reason only restates that every device has a different address, which the mark scheme says does not earn the second mark.

No marks0/2

So it can connect to the internet.

Why: No linked explanation of how the address is used; 'so it can connect to the internet' is not accepted without expansion.

4Calculate2 marksBinary Shifts Swap Remove

Computers manipulate binary patterns.

Complete the table with the result of applying the shift to the binary pattern.

[2 marks]
Binary patternShift8-bit binary result
1000 0001Logical shift right by 1
Mark scheme

Award one mark for each correct nibble in the correct order:

  • 0100 (1)
  • 0000 (1)

0 marks if the response is not 8-bit binary.

Example answers and how they were marked
Full marks2/2

0100 0000

Why: Every bit moves 1 place right, with 0s in from the left: both nibbles are correct (2).

Some marks1/2

0100 0001

Why: A slip in the last bit. The first nibble is correct (1); the second is not.

No marks0/2

0000 0010

Why: Shifts the bits the wrong way. Neither nibble is correct.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Network Security Risks 16 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.