Menu
Exam Questions

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 659 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

3 questions · 4 marks

Pick again
Print
1Multiple choice1 markUnits & Conversion Swap Remove

Units of data storage can be binary or decimal.

Identify the unit of storage that is equivalent to 1024 gibibytes.

[1 mark]
  • AGibibyte
  • BMebibyte
  • CTebibyte
  • DTerabyte
Mark scheme
  • C Tebibyte (1)
  • The only correct answer is C. The correct answer is tebibyte.
  • A is not correct because a gibibyte is 1024 mebibytes
  • B is not correct because a mebibyte is 1024 kibibytes
  • D is not correct because a terabyte is 1000 gigabytes
Example answers and how they were marked
Full marks1/1

C Tebibyte

Why: Correct: 1024 gibibytes make one tebibyte (1).

No marks0/1

A Gibibyte

Why: Near miss: a gibibyte is 1024 mebibytes, not 1024 gibibytes (0).

No marks0/1

D Terabyte

Why: Typical misconception: uses the decimal terabyte (1000 gigabytes) instead of the binary tebibyte (0).

2Short recall1 markTopologies Swap Remove

A bus topology uses terminators at each end of the main cable.

State the purpose of terminators in a bus topology.

[1 mark]
Mark scheme

Award one mark for:

  • Absorb signals (at the ends of the bus cable) / prevent signals reflecting (back along the cable) (1)

Allow 'stop data/signals bouncing back' for prevent signals reflecting

Do not accept 'terminate the cable' / 'close the end of the cable' on its own

Do not accept boost/repeat/strengthen the signal

Example answers and how they were marked
Full marks1/1

To absorb signals so that they do not reflect back along the bus cable.

Why: Absorbing signals and preventing reflection are alternatives within the one creditworthy point (1).

No marks0/1

To terminate the cable at each end.

Why: Near miss: this is rejected by the 'terminate the cable' guidance because it does not say signals are absorbed or prevented from reflecting.

No marks0/1

To make the signal stronger at the end of the cable.

Why: Misconception: terminators absorb signals; they do not boost, repeat or strengthen them.

3Short recall2 marksUnits & Conversion Swap Remove

A solid state drive has a capacity of 5 gibibytes.

Give an expression to calculate the number of bits in 5 gibibytes. You do not need to do the calculation.

[2 marks]
Mark scheme

Award one mark for each of:

  • 5 × 1024^3 / 5 × 1024 × 1024 × 1024 / 5 × 2^30, for the number of bytes (1)
  • A fully correct expression with × 8 to convert bytes to bits, in any order, e.g. 5 × 1024^3 × 8, 8 × 5 × 2^30 (1)

Accept 5 × 1 073 741 824 × 8.

Accept 5 × 2^33 or 42 949 672 960 as a fully correct expression (2 marks).

Do not accept 5 × 1000^3 × 8, which uses decimal multiples.

Do not accept ÷ 8, which converts bits to bytes.

Example answers and how they were marked
Full marks2/2

8 × 5 × 2^30

Why: 5 × 2^30 is the number of bytes (1) and × 8 converts bytes to bits (1).

Some marks1/2

5 × 2^30

Why: Correct number of bytes using the binary multiple 2^30 (1), but no conversion to bits.

No marks0/2

5 × 1000^3 × 8

Why: Uses decimal 1000^3 instead of binary 1024^3, so the expression is not fully correct; no creditworthy point.

Questions by topic

2.1 Binary

Build a paper on this topic 58
Adding Binary Numbers 6 questions Binary and Hexadecimal Basics 10 questions Binary Shifts 6 questions Binary to Denary Conversion 6 questions Binary to Hexadecimal Conversion 6 questions Denary to Binary Conversion 6 questions Denary to Hexadecimal Conversion 6 questions Denary to Negative Binary Conversion 6 questions Hexadecimal to Binary Conversion 6 questions

2.2 Data representation

Build a paper on this topic 56
Character Sets 18 questions Images 19 questions Sound 19 questions

2.3 Data storage and compression

Build a paper on this topic 24
Compression 18 questions Units & Conversion 6 questions

3.1 Hardware

Build a paper on this topic 77
Embedded Systems 17 questions Fetch Decode Execute Cycle 15 questions Primary Memory 15 questions Secondary Memory 15 questions Stored Program Computers 15 questions

3.2 Software

Build a paper on this topic 124
File Management 18 questions Memory Management 16 questions Peripheral Management 11 questions Process Management 12 questions Purpose & Function of Operating Systems 17 questions Software Basics 13 questions User Management 18 questions Utility Software 19 questions

3.3 Programming languages

Build a paper on this topic 37
Low and High Level Languages 19 questions Translators 18 questions

4.1 Networks

Build a paper on this topic 138
Addressing 16 questions LANs & WANs 16 questions Network Speed 5 questions Packet Switching 16 questions Protocols & Layers 17 questions The Internet 16 questions Topologies 17 questions Wired Connections 17 questions Wireless Connections 18 questions

4.2 Network security

Build a paper on this topic 36
Network Security Risks 18 questions Preventing Network Security Risks 18 questions

5.1 Environmental

Build a paper on this topic 36
E-waste 17 questions Manufacturing Technology 19 questions

5.2 Ethical and legal

Build a paper on this topic 65
Data Protection Act 17 questions Impact of AI 18 questions Intellectual Property 18 questions Software Licences 12 questions

5.3 Cybersecurity

Malware 8 questions

More ways to revise Edexcel GCSE Computer Science (1CP2)

Activities Flashcards Revision notes

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.