Edexcel GCSE Computer Science (1CP2) Exam Questions

• B Data is permanently removed to reduce the file size (1)
• The only correct answer is B. The correct answer is data is permanently removed to reduce the file size.
• A is not correct because the data removed by a lossy algorithm is not restored after transmission
• C is not correct because that describes lossless compression, where the original file is rebuilt exactly
• D is not correct because dictionary encoding is a lossless method that records repeated patterns once

• D Time slice (1)
• The only correct answer is D. The correct answer is time slice.
• A is not correct because a process is a program that is being run
• B is not correct because round robin is a scheduling method that takes turns, not the period of CPU time itself
• C is not correct because a scheduler decides which process runs next

Award one mark for any of the following up to a maximum of one mark:

• Breaks messages/data into packets (1)
• Reassembles packets (at the destination) (1)
• Detects errors (1)
• Resends lost/missing packets/requests retransmission of lost packets (1)
• Creates/establishes a connection between two computers/hosts/sets up a connection before data is sent (1)

Do not accept routing packets or using IP addresses, which is the role of IP.

Do not accept encrypting data or providing security.

Do not accept vague answers such as 'transmits data' or 'sends data' without saying how TCP does this.

Award up to two marks for a linked description such as:

• It reads/monitors the temperature/humidity/light level using sensors (1) to switch the heaters/vents/lamps/watering system on or off when the reading is outside the set range (1)
• It compares the readings from the sensors with the set values/thresholds stored in its memory (1) to decide whether the conditions need to be changed (1)
• It monitors the light level using a light sensor (1) and turns the lamps on when the light falls below the level the plants need (1)
• It monitors the soil moisture using a soil moisture sensor (1) and turns the water pump/irrigation on when the soil is too dry (1)

For the second mark, the action/response must be linked to the sensor reading given in the first point.

Allow named sensors (temperature/humidity/light/soil moisture) and named outputs (heater, fan, vent/window, lamp, irrigation/water pump).

Do not accept answers that only name a sensor or only name an output, e.g. 'it has a temperature sensor and a heater', as there is no link between the reading and the control action.

Do not accept answers where a person switches the equipment on or off, as the embedded system controls the conditions automatically.

Award up to two marks for a linked description such as:

• Repeated words/patterns are found (1) and stored once in a dictionary with a code (1)
• Each repeated word/pattern is replaced by a shorter code (1) so fewer bits are needed to store the text (1)
• No data is removed (1) so the original text can be recreated exactly (1)
• The compressed file is smaller (1) but all the original characters can still be restored (1)

Do not accept answers that say data is permanently removed or quality is reduced.

Award up to two marks for a linked explanation such as:

• Only a limited number of different amplitude values can be stored (1) so each sample is rounded to the nearest available value and the digital wave does not match the analogue wave exactly (1)
• The wave is continuous but only a limited set of values can be represented (1) so amplitude detail/accuracy is lost (1)
• Quiet and loud parts of the sound may be stored as the same value (1) because there are too few values to tell them apart (1)
• The range of amplitudes that can be represented is limited (1) so the loudest/quietest parts of the sound cannot be stored accurately (1)

For both marks, the expansion must follow/associate with the statement.

Do not award marks for answers that say the sound cannot be stored or heard at all.

Do not award answers about the number of samples taken/sample rate, as the number of bits limits the amplitude values, not how often the wave is sampled.

Do not accept 'lower quality'/'less accurate'/'less detail' on its own without a link to the amplitude values that can be stored/the number of bit combinations.

Do not accept 'the file size is smaller' without a link to the accuracy or the range of values that can be stored.

Award up to two marks for a linked explanation such as:

• The programmer can control/manipulate the hardware directly (1) because low-level instructions can access registers/memory addresses/hardware features (1)
• The code can be made to work efficiently with a specific device (1) because low-level languages are processor/chipset specific, so the instructions match that hardware (1)
• The code produced is fast to execute (1) because it is optimised for the specific processor/uses few instructions (1)
• The code produced is small (1) so it fits in the limited memory/ROM available in the device (1)

For both marks, the expansion must follow/associate with the statement.

Fast execution and small code size are typical advantages of low-level languages; award them only where the linked reason relates to the device.

Do not accept 'it is easier to write/learn/understand' or 'it is faster to write' as a point or as the expansion, because low-level languages are not easier for these.

Do not accept 'it is close to the hardware' or 'it works with hardware' without expansion of what that allows the program to do.

Do not accept 'because it is low-level' as the expansion; the answer must say what the language/hardware allows.

Indicative content

How each translator deals with a syntax error

• An interpreter stops as soon as it finds a syntax error and displays an error message.
• With an interpreter, the lines before the error have already been executed, so the student can see how far the program got before it stopped.
• A compiler reports errors at the end of translation, so the student gets a list of all the syntax errors in the program in one go.

How much of the program is translated at a time

• An interpreter translates one line at a time and executes each line immediately.
• A compiler translates the whole program in one go before any of it is run.
• A compiler produces object code, so after every change the whole program must be compiled again before the student can run it.
• An interpreter produces no object code, so the student does not have to wait for the whole program to be translated before it runs.

How this affects the student's testing

• An interpreter suits this student because the program can be run straight away after each small change.
• The interpreter stops at the first error found, so the student fixes that error and runs the program again, but may only find the next error on the next run.
• Reporting every error at the end of compilation means the student can fix several errors at once, but cannot run the program until the whole program compiles.
• The student should use an interpreter while testing, and compile the finished program once it works.

Levels

• Level 0 (0 marks): No rewardable content.
• Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
• Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
• Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Level 3 responses must relate the way each translator works to the student's testing, not just describe the two translators.

Do not accept answers about run-time or logic errors where no comparison of the translators is made.