Edexcel GCSE Computer Science (1CP2) Exam Questions

• B To reduce the time taken to transmit a file (1)
• The only correct answer is B. The correct answer is to reduce the time taken to transmit a file.
• A is not correct because compression reduces file size, which can reduce the number of packets sent
• C is not correct because lossy compression can reduce the quality of a file
• D is not correct because encryption, not compression, can make a file harder to open

• B The destination IP address (1)
• The only correct answer is B. The correct answer is the destination IP address.
• A is not correct because a domain name is converted to an IP address by a DNS server before routing begins
• C is not correct because the sender's MAC address is only used to deliver the packet on the local network
• D is not correct because the file name is not used to route packets

Award one mark for:

• Absorb signals (at the ends of the bus cable) / prevent signals reflecting (back along the cable) (1)

Allow 'stop data/signals bouncing back' for prevent signals reflecting

Do not accept 'terminate the cable' / 'close the end of the cable' on its own

Do not accept boost/repeat/strengthen the signal

Award one mark for:

• 164 (1)

Award one mark for any of the following up to a maximum of two marks:

• (Only) 128 different characters can be represented / 7 bits give 2^7 = 128 different codes (1)
• It cannot represent characters from languages other than English / non-English alphabets, e.g. Greek, Chinese (1)
• It cannot represent accented characters, e.g. é, ñ (1)
• It cannot represent symbols or emoji that are not in the ASCII character set (1)

Award a maximum of one mark for the last three bullets, as they are all examples of characters that fall outside the 128 ASCII codes.

Allow 'it can only represent 128 characters, so some characters are missing' for the first bullet.

Do not accept 'it uses 7 bits' / 'it only uses 7 bits' on its own, without saying what this limits.

Do not accept 'it can only store a limited amount of text' / 'it can only store short messages', as 7 bits limits the number of characters available, not the length of a message.

Do not accept 'it can only represent the characters in the ASCII character set', as this repeats the question.

Do not accept 'it is old/out of date' or 'it cannot store numbers'.

Award up to two marks for a linked description such as:

• The processor/CPU can only execute machine code/binary instructions (1) so the assembly instructions must be converted into machine code before the program can run (1)
• Each assembly instruction/mnemonic matches/corresponds to one machine code instruction (1) so each line must be replaced with the machine code the processor executes (1)
• The program is written using mnemonics (1) that must be translated into machine code for the processor to carry out the instructions (1)
• The hardware/processor does not understand assembly language directly (1) so it must be translated into machine code that the processor can execute (1)

Do not accept 'assembly language is a low-level language'.

Do not accept 'it is hard to understand' or 'it is not English'.

Do not accept benefits, such as 'machine code runs faster' or 'the program will run more quickly'.

Do not accept 'an assembler/a translator converts it' on its own, with no reference to the processor only being able to execute machine code/binary.

Do not accept responses about high-level languages or about compilers/interpreters.

Award one mark for each correct nibble in the correct order:

• 1100 (1)
• 0111 (1)

0 marks if the response is not 8-bit binary.