Menu

Edexcel GCSE Computer Science (1CP2) Exam Questions

Build a practice paper from 514 exam-style questions, each with its mark scheme and example answers. Print it, or answer it on paper and then open the mark schemes. Or browse the questions by topic.

Build a paper

Topics (none ticked: all of them)
Question types (none ticked: all of them)

Practice paper

6 questions · 15 marks

Pick again
Print
1Multiple choice1 markSound Swap Remove

A sound wave is sampled and the amplitude of each sample is stored using 2 bits.

Identify the number of different amplitude values that can be stored for each sample.

[1 mark]
  • A2
  • B4
  • C8
  • D16
Mark scheme
  • B 4 (1)
  • The only correct answer is B. The correct answer is 4 (2 bits give 2^2 = 4 values).
  • A is not correct because 2 is the number of bits used to store each sample
  • C is not correct because 8 different amplitude values would need 3 bits
  • D is not correct because 16 different amplitude values would need 4 bits
Example answers and how they were marked
Full marks1/1

B 4

Why: Selects the only correct option (1).

No marks0/1

C 8

Why: Near miss: 8 values would need 3 bits, one more than this recording uses (0).

No marks0/1

A 2

Why: Typical misconception: 2 is the number of bits, not the number of amplitude values those bits can store (0).

2Short recall2 marksStored Program Computers Swap Remove

Computers use the von Neumann stored program concept.

Define the term stored program concept.

[2 marks]
Mark scheme

Award one mark for any of the following up to a maximum of two marks:

  • Program instructions are stored in main memory/RAM (1)
  • The data used by the program is stored in main memory/RAM (1)
  • The CPU fetches/reads instructions from main memory to execute them (1)
  • The program can be run without the instructions being input again (1)

Allow 'the program is stored in memory' for one mark.

Do not accept answers about programs being stored on secondary storage, such as a hard disk or USB memory stick.

Do not accept answers that only describe the von Neumann architecture (e.g. having a CPU and memory) without stating that instructions are stored in main memory.

Example answers and how they were marked
Full marks2/2

Both the program instructions and the data the program uses are held in the same main memory, and the CPU fetches these instructions from memory to execute them.

Why: Instructions stored in main memory (1) and the CPU fetches instructions from memory to execute them (1).

Some marks1/2

Program instructions are stored in main memory.

Why: Instructions stored in main memory (1). No second point about data being stored in the same memory or about the CPU fetching instructions.

No marks0/2

The program is saved on the hard disk so that it can be loaded into RAM when the user runs it.

Why: A near-miss about secondary storage, which the mark scheme says not to accept; the stored program concept is about instructions being held in main memory.

3Describe2 marksLow and High Level Languages Swap Remove

A programmer has written a program in assembly language.

Describe why it is necessary to translate the program into machine code before it can be run.

[2 marks]
Mark scheme

Award up to two marks for a linked description such as:

  • The processor/CPU can only execute machine code/binary instructions (1) so the assembly instructions must be converted into machine code before the program can run (1)
  • Each assembly instruction/mnemonic matches/corresponds to one machine code instruction (1) so each line must be replaced with the machine code the processor executes (1)
  • The program is written using mnemonics (1) that must be translated into machine code for the processor to carry out the instructions (1)
  • The hardware/processor does not understand assembly language directly (1) so it must be translated into machine code that the processor can execute (1)

Do not accept 'assembly language is a low-level language'.

Do not accept 'it is hard to understand' or 'it is not English'.

Do not accept benefits, such as 'machine code runs faster' or 'the program will run more quickly'.

Do not accept 'an assembler/a translator converts it' on its own, with no reference to the processor only being able to execute machine code/binary.

Do not accept responses about high-level languages or about compilers/interpreters.

Example answers and how they were marked
Full marks2/2

The processor can only execute machine code, so the assembly instructions must be converted into machine code before the program can run.

Why: States what the processor can execute (1) and links it to converting the program's instructions into machine code (1).

Some marks1/2

Each assembly instruction matches one machine code instruction.

Why: Correct point about the one-to-one match (1) but no development saying that this is because the processor only executes machine code.

No marks0/2

Because an assembler translates assembly language into machine code.

Why: Names the translator but gives no reason tied to the processor only being able to execute machine code, so no mark; this is in the 'Do not accept' guidance.

4Explain2 marksPacket Switching Swap Remove

A file is sent across the internet in packets.

Explain why packets from the same file may take different routes.

[2 marks]
Mark scheme

Award up to two marks for a linked explanation such as:

  • Each router chooses the best route at the time (1) so when a route becomes busy/congested or fails, later packets are forwarded along a different path (1)
  • Routers forward each packet separately (1) so the path a packet takes depends on the traffic conditions when that packet arrives (1)
  • A router may send a packet to a different next router (1) if its routing table shows a better/less congested route for that packet (1)
  • Traffic on the internet changes (1) so no single path is kept for the file and each packet can use whichever route is best when it is sent (1)

For both marks, the expansion must follow/associate with the statement.

Allow reference to a routing table, or to how a router decides the route, as part of the linked reason.

Do not accept 'the packets have different IP addresses' because all packets from the same file have the same destination IP address, even though their routes can differ.

Do not accept 'the internet is busy' or 'there is a lot of traffic' on its own without linking this to the router choosing a different route.

Do not accept 'different routers send the packets' on its own without a reason why a different router/route is chosen.

Do not accept an answer that only says the packets take different routes without explaining why.

Example answers and how they were marked
Full marks2/2

Each router chooses the best route at the time, so if one route becomes busy or fails, later packets are sent a different way.

Why: Linked point (1) that each router chooses the best route at the time and reason (1) that a busy or failed route means later packets take a different path.

Some marks1/2

Routers send packets along the least congested route.

Why: States that a router chooses the least congested route (1) but gives no linked reason why this makes the packets from the file take different routes.

No marks0/2

Because each packet is given a different IP address so they go to different places.

Why: Misconception named in the mark scheme: all packets from the same file share the same destination IP address, even though their routes can differ.

5Calculate2 marksAdding Binary Numbers Swap Remove

Computers manipulate binary patterns.

Complete the table to show the result of the 8-bit binary addition.

[2 marks]
1286432168421
10010101
01001111
Mark scheme

Award one mark for each correct nibble in the correct order:

  • 1110 (1)
  • 0100 (1)

0 marks if the response is not 8-bit binary.

Example answers and how they were marked
Full marks2/2

1110 0100

Why: 149 + 79 = 228, carrying where a column adds to 2: both nibbles are correct (2).

Some marks1/2

1110 0101

Why: A slip in the last bit. The first nibble is correct (1); the second is not.

No marks0/2

1101 1111

Why: Writes 1 in every column with a 1 and never carries. Neither nibble is correct.

6Discuss6 marksUser Management Swap Remove

A school library has 24 computers that are shared by students and teachers throughout the day. Each computer runs an operating system. The school wants users' work to be kept private and the computers to be used only by authorised people.

Discuss how the operating system's user management features can be used to share the computers securely.

Your answer should include:

  • user accounts
  • authentication
  • the benefits for the school.
[6 marks]
Mark scheme

Indicative content

User accounts

  • Each student and teacher should have their own user account, so the operating system can identify the person who is logged on.
  • The operating system keeps a record of all valid users on the computer, so unknown users are not allowed to log in.
  • A separate home area or folder can be created for each account, so a student's saved work is kept apart from other users' work.
  • An account can be disabled when a student leaves the school, so they can no longer access the computers.

Authentication

  • A username and password can be required at login, so only users with the correct details can use the computer.
  • The operating system checks the entered password against the stored password for that account before allowing access.
  • Users should be encouraged to choose a strong password, which makes it harder for someone else to guess and log in.
  • The operating system can lock an account after several failed login attempts, which reduces the chance of someone trying passwords repeatedly.

Benefits for the school

  • Many students can share the same computers because each person's files are kept separate.
  • Work is less likely to be deleted or changed by another student, because users only see their own files.
  • The school can see which account was used on a computer, so misuse can be traced to a user.
  • Teachers can be confident that only authorised people can use the library computers.
  • The school does not need a separate computer for every student, so it saves money.

Levels

  • Level 0 (0 marks): No rewardable content.
  • Level 1 (1–2 marks): Basic, independent points are made, showing elements of understanding of key concepts/principles of computer science. (AO1) The discussion will contain basic information with little linkage between points made or application to the context. (AO2)
  • Level 2 (3–4 marks): Demonstrates adequate understanding of key concepts/principles of computer science. (AO1) The discussion shows some linkages and lines of reasoning with some structure and application to the context. (AO2)
  • Level 3 (5–6 marks): Demonstrates comprehensive understanding of key concepts/principles of computer science to support the discussion being presented. (AO1) The discussion is well developed, with sustained lines of reasoning that are coherent and logically structured, and which clearly apply to the context. (AO2)

Level 3 responses must cover both user accounts and authentication, and apply them to the school library.

Do not accept general operating system functions such as file management or process management unless they are explicitly linked to managing users.

Example answers and how they were marked
Full marks6/6

Each student and teacher should have their own user account with a username and password. When someone logs in, the operating system checks the password against the one stored for that account, so only authorised people can use the computer. Each account can have its own home folder, so a student's work is kept private and another student cannot open or delete it. If a student leaves the school, their account can be disabled so they cannot log in again. This lets the school share a smaller number of computers safely, as each user's work stays separate and any misuse can be traced to the logged-in account.

Why: Level 3. It explains user accounts, authentication and benefits, with sustained links to sharing computers in the school library.

Some marks4/6

Every user should have a username and password. The operating system checks the password so that people who are not allowed cannot log in. Each user should also have their own area to save files so they do not delete other people's work.

Why: Level 2. Basic accounts and authentication points are made and linked, but the benefits to the school are only briefly applied and not developed.

No marks0/6

The operating system manages the users by looking after the files in folders and by making sure the printer works for everyone. It also keeps the computer running quickly when lots of students use it.

Why: Level 0. These are general operating system functions such as file management and peripheral management, not user management, so no creditworthy point is made.

Questions by topic

More ways to revise Edexcel GCSE Computer Science (1CP2)

Teachers: build a paper, print it with the mark schemes at the end, and sign your school up to set your classes activities on every topic.

Fetch Decode Explain isn't affiliated with or endorsed by Pearson Edexcel.